22
Installation
•Do not install this appliance if it is
damaged in any way. Installing a
damaged appliance may invalidate the
warranty.
•The water supply tap should be located
in an adjacent cupboard so that it can be
accessed after installation.
•Ensure the appliance is level by adjusting
the feet as necessary.
The dishwasher is equipped with an
adjustable rear foot that can be raised
or lowered by means of an adjustment
screw, located in the centre of the kick
plate.
•Only use the water inlet supplied with
the appliance.
• If the water pressure is above 10 bar, a
pressure relief valve should be used.
• After connecting the water supply, check
to ensure there are no leaks.
•The water outlet can either be connected
to a water drain or to a sink outlet spigot.
This connection should be at a minimum
of 50 cm and a maximum of 110 cm from
the floor. The drain hose should be no
longer than 4m in length to ensure good
performance from the dishwasher.
fig. 19
fig. 17
fig. 18
To Next Page
Loading...
