131
CHAPTER 10: BIKE SPECIFICATIONS AND ASSEMBLY GUIDE
10.5 TV PROGRAMMING INSTRUCTIONS (ID MARKET)
Once the cardio equipment has been installed and proper power and cable wiring is provided, The Television must be programmed to the club's
channels and settings.
Auto Tuning - An auto scan will search for channel signals from the coax cable. It will tune in all channels that provide a signal of sufficient
strength.
1. Press ENTER, 1, 0, 0, 1, ENTER on the number keypad to enter Manager Mode.
2. Press TV on the screen (Figure A).
3. Select the tuner type on the screen (Figure B).
4. Select the source on the screen (Figure C). If your source is digital, select DVBT and continue onto Steps 5-6 for TV programming. If your source
is analog, select Analog and skip to the Steps 7-9 for TV programming.
5. Press Start Scan to begin scanning (Figure D).
6. Scan Started will be displayed on the bottom left hand corner of the screen (Figure E). Once the channel scan is complete, the scanned channels
will be displayed on the channel list on the screen (Figure F).
FIGURE BFIGURE A
FIGURE C
FIGURE D
FIGURE E
FIGURE F
To Next Page
Loading...
Need help?
General
