146
10.7 NETPULSE & AM SETTING UP SOP
Option 2: A wireless connecting solution
The media Gateway is connected to a local internet source. The Gateway is the connected to one or more Meraki MR24 Wireless Access
Points. Each AP can support up to 20 pieces of 7xi cardio equipment.
Please see notes below regarding how to determine the number of Access Points are necessary at a given install.
Wireless Installation Steps:
1. Prepare site for local server and internet connection
a. Find a secure location (like an AV closet or a server room) for the gateway and related network equipment.
b. Make sure the location has power and internet access, as well as a rack or 19” shelf for the gateway.
c. Contract an ISP (Internet Service Provider) to bring internet connectivity to the closet.
i. The minimum bandwidth is 3Mbps down.
ii. Recommended is a bandwidth of 1Mbps down for every 4 Touchscreens.
2. Perform a Site Survey to determine the Access Point Needs of the facility.
a. There are four basic steps to design a wireless network.
i. Identifying areas that need coverage and estimating the number of APs needed.
ii. Running cable from the communications closet to the APs mounting locations.
iii. Mounting the APs.
iv. Coverage Check
Wireless Gateway setup for 7xi
CHAPTER 10: BIKE SPECIFICATIONS AND ASSEMBLY GUIDE
CHAPTER 10: BIKE SPECIFICATIONS AND ASSEMBLY GUIDE
To Next Page
Loading...
Need help?
General
