74 Appendix C: Matrox Imaging operating system utilities and recovery
Matrox Imaging operating system utilities
Matrox Iris GTX includes several useful utilities. They are available from the
following web address:
In the above example, replace xxxxxx with the six digits of your smart camera’s
MAC address. If you have changed the camera’s device name, replace GTXxxxxxx
with the name of your smart camera, or use its IP address; for more information,
see Connecting to your Matrox Iris GTX desktop section, in Chapter 2: Powering and
connecting to your Matrox Iris GTX.
Note that these utilities are stored on your Matrox Iris GTX, but should be
installed on your development computer, in case the operating system partition
becomes corrupt and you need to use these programs. They can be downloaded
from your Matrox Iris GTX’s web address, shown at the top of this section.
The utilities offered are as follows:
• Virtual network computing (VNC). This utility allow you to remotely connect
to your Matrox Iris GTX.
• Matrox System Discovery (MtxSysDiscovery) utility. This 64-bit Windows
utility allows you to discover Matrox Iris GTX cameras on your network. In
addition, it can change network settings, restart or shut down individual smart
cameras, or open the portal page of a specific camera. On computers with Matrox
Design Assistant installed, this utility is included in the To o ls folder, accessible
from the MIL Control Center.
• Bonjour browser. This is a link to the Internet that leads to the Bonjour browser
website. Bonjour browser is a program that lists all the services on your subnet.
This provides a way to find the IP address of any Matrox Iris GTX on the subnet.
http:\\GTXxxxxxx:8080
To Next Page
Loading...
