67
Set Supervisor and User Passwords
These items can be used to install a password. A Supervisor
password takes precedence over a User password, and the
Supervisor can limit the activities of a User. To install a
password, follow these steps:
1. Highlight the item Set Supervisor/User password on the
main menu and press <Enter>.
2. The password dialog box appears.
Enter Password:
3. If you are installing a new password, type in the password.
You cannot use more than eight characters or numbers. The
Set Supervisor/User Password item differentiates between
upper case and lower characters. Press <Enter> after you
have typed in the password. If you are deleting a password
that is already installed just press <Enter> when the
password dialog box appears. You see a message that
indicates that the password has been disabled.
PASSWORD DISABLED !!!
Press any key to continue . . .
4. The system will ask you to confirm the new password by
asking you to type it in a second time.
Confirm Password:
5. Type the password again and press <Enter>, or just press
<Enter> if you are deleting a password that is already
installed.
6. If you typed the password correctly, the password will be
installed.
To Next Page