Chapter 4 Preparation for Operation
- 30 -
[WO-8525]
Confirmation unit and checking item
No.3 Material
beginning timer
(In secondary convey
with two directions,
box under the
dry unit is
specification with the
profile damper (Push
damper).)
Press the SV switch.
Press a present setting value alternately until a bt3 is displayed on the
indicator.
Press the Enter switch.
The present setting value blinks on the indicator.
The Material beginning time changes by the conveying distance and
kind of the material. Set time up before inside of the hopper on the
molding unit is in the material fullness.
Push the ▲ ▼
switch and change the setting value.
When pushing these switches, the value becomes the addition and the
subtraction in order.
Also, when continuing to push a switch, automatically, the value
becomes an addition and a subtraction.
Push the Enter switch and input the setting value.
When not pushing this switch, the setting value can not be changed.
Surely, press.
1.Setting range………………999 sec.
2.Shipment setting value……2 sec.
3.Standard setting value
In case of the suction box installing
without the profile damper….0 sec.
In case of the suction box installing
with the profile damper…….2 sec.
To Next Page
