Chapter 1 Safety Precautions
- 3 -
[WO-8525]
Precaution item Description
Opening and closing the
vertical body and the cleaning
Please incline it until being affix the hand to the vertical body soon without
fail so as not to give the impact after the thing that there is no material in the
inside is confirmed from the level window, and stopping slowly when
opening and shutting.
Maintenance
Before performing maintenance procedures, be sure to turn the circuit breaker
on the right side of the control panel to “OFF”.
When there is equipment that uses the compressor air, performed to maintain
after stopping the compressor air and pulling out the rest pressure in the pipe.
Even if it stops the operation, for a while, the hot condition continues.
Until the equipment gets cold sufficiently, wait for the work.
(You make a 5 h elapse a standard by the nature cooling). Also, even if the
equipment outside is cold, a still hot part is sometimes left about the
equipment inside or the dry material. Therefore, when touching equipment,
wear a glove and a protection tool. Then, be sure to do not touch the
equipment in a bare hands and skin.
Do not ride and hang a leg on the equipment. It is very dangerous.
The cleaning of each filter is indispensable to maintain the equipment
performance. Performs the regular cleaning and don't operate with the dirty
filter. As for contents of cleaning, refer to Chapter 6 Maintenance.
During the equipment operation, don't do the removal of filter and the
cleaning absolutely. It causes trouble and accident. Also, install the filter
surely right.
The breaker points of electromagnetic contact unit wears away when using
the equipment among long-term. Then, the breaker point does deposit and the
heater always becomes the turning on condition.
Of this has a possibility to cause important accidents such as the fire.
Therefore, before the equipment
starts, always perform to check the
electromagnetic contact unit. For the check details, refer to
Remodeling of equipment
Don't use in the remodeling of equipment. This causes trouble and
accident. Also, we cannot do warranty to the trouble in use of the
Warning labels
Name plate
According to the dangerous level, label affixes to caution part in the
product. Performs to operate after understanding the contents of warning
Keep legible until this equipment is disposed of. Benzene, paint thinner,
scouring powders, etc. will damage the surface.
To clean dirty equipment,
wipe with a soft cloth which has been soaked in water at 40°C and wrung out
Wiping clean
Do not wipe with petroleum solvents. Benzene, paint thinner, scouring
powders, etc. will damage the surface. To clean dirty equipment, wipe with a
soft cloth which has been soaked in water at 40°C and wrung out well.
To Next Page
Loading...
