BLADE
3-5
TI215G0010
BUILTIN DRYER VERSION PLUS
Each BLADE 15÷22 unit is supplied with a compressed
air cooling radiator. Cooling produces condensation that
is un-loaded from specic separators and drainpipes
that can be applied on the front of the machine (see this
section Optional Accessories).
Many industrial applications require that the
compressed air be al-most completely emptied from
the water vapour it contains so as to prevent any further
condensation from forming inside the line pipes to
which it is connected. Hence, devices that lower the dew
point by a few degrees above 0°C should be installed.
In the Plus versions the setting up of the machine
includes a dryer with a refrigerator cycle that guarantees
an adequate compressed air quality. The design of
the compressor allows for integrating a dryer with
refrigerator cycle directly installed on the machine. An
electronic controller controls the dryer, which manages
its functional parameters according to the dierent
operating load cycles.
The Plus versions are equipped with electronic drain
(see p. 3-7, item 17). Mattei suggests performing device
maintenance every two years.
For further details on the dryer, please refer to the
specic manual supplied with the device.
WARNING !!!
For compressors in the Plus version see tables
“Electricity supply for compressor and dryer”
on page 5-2.
ID Plate
The product ID plate contains all the machine’s essential
data.
Removing or tampering the id plate forfeits the right of
guarantee.
Description of the machine
To Next Page
Loading...
Need help?
General
