Max SN890CH 34 User Manual

5. INSTRUCTIONS FOR
OP.
ERATION
READ SECTION TITLED
''SAFEW
IN.
STRUCTIONS'"
1. BEFORE OPERATION
Check the following
prior
operation.
O
Wear Safety Glasses
or Goggles.
O
Oo not connect the air supply.
(O
lnspect
screw
tightness.
@
Cneck operation of the contact arm & trigger
if moving smoothly.
(9
Connect the air supply.
GD
Cnecf the air-leakage.
(The
Tool must not
have
the air-leakage.)
O
noH the Toolwith
finger-off
the
trigger,
then
push
the contact arm against the work-piece.
(The
tool
must
not
operate.)
@
noH
the
Toolwith
contact arm
free from
work-piece and
pullthe
trigger.
(The
Tool
must not
operate.)
O
Disconnect the air supply.
WARNING
2.
OPERATION
Wear
safety
glasses
or
goggles
danger to the
eyes
always exists due to the
possibility
of dust
being blown up by the exhausted air
or
of
a fas-
tener flying up due to the
improper handling
of
the tool.
For these reasons, safety
glasses
or
goggles
shall always be
worn when
operating
the tool.
The
employer and/or user
must ensure
that
proper
eye
protection
is worn. Eye
protection
equipment must conform to the
requirements
of
the
American National Standards
Institute, ANSI
Z.87.1
(CouncilDirective
89/686/EEC
of 21 DEC.
1989)
and
provide
both
frontaland
side
protec-
tion.
The
employer
is
responsible
to enforce the use
of eye
protection
equipment by the tool operator
and all other
personnel
in the work area.
NOTE:
Non-side
shielded spectacles
and face
shields alone do
not
provide
adequate
protection.
▲
ｗ
Ａ Ｒ
Ｎ ︲
Ｎ
Ｇ
Ｎ
Ｇ
︲ ﹂ ﹂ Ｏ Ａ Ｄ ︲
Ａ
一
一
¨
Ａ Ｎ
Keep
hands
and body
away from the discharge
outlet
when driving the
fasteners
because
of
dangerous
of hitting the
hands
or body
by
mis-
take.
.
When loading the
nails, be sure to release
the
finger from the
Trigger.
.
Do not
press
the
Contact Arm against the
object.
PROCEDURE
C
LoaO the
nails into the slot in the
rear
of the
Magazine untilthey
go
overthe NailStopper

Max SN890CH 34 Specifications

General

Brand	Max
Model	SN890CH 34
Category	Nail Gun
Language	English