Max SN890CH 34 - Actuation Modes and Switching

C)PullthePusherasfarastherearendofthe
magazineandreleaseitgently.
Abrupt release of the
Pusher
causes
jamming
of nails or dry-firing.
TEST
OPERATION
O
nOlust the air
pressure
at 5 bar
(70
p.s.i.)
and
connect
the air supply.
O
Witnout touching the trigger, depress the
contact arm
against the work-piece.
Pullthe
trigger.
(The
tool must fire the
fas-
tener.)
(9
Wtn the tool off the
work-piece,
pull
the trig-
ger.
Then
depress the contact arm against the
work-piece.
(The
tool
must fire
the
fastener.)
@
ROlust the air
pressure
as
much
as the
low-
est
possible
according the
length
of
faslener
and the
hardness of work-piece.
▲
CAUT:ON
Ｗ
ｈ ｉ
Ｇ
﹂
Ｔ ｈ ｉ
Ｓ
ｔ
︒ ︒
︲ ｉ
Ｓ Ｓ
一
▲
¨
DR:VINGFASTENERS
SINGLEACTUAT10N
.
To
avoid double
firing or accidental firing,
pull
the trigger npidly
and firmly.
.
SINGLE
ACTUATION is different from SE-
QUENTIAL
TRIP.
.
The toolwith SINGLE
ACTUATION
drives
a
nail
each time
both when depressing the
Contact Arm while
keeping
the
Trigger
pulled,
and
when
pullimg
the Trigger and
keeping it
pulled
after the
Contact
Arm
de-
pressed.
SINGLE ACTUATION OPERATION
For
SINGLE
ACTUATION operation, keep the
Trigger
pulled
and depress the
Contact Arm
against the
work surface, or depress the Contact
Arm against the work surface and
pull
the
Trig-
ger
and keep
it
pulled.
Tool
cannot
fire
a second
nail until the
Trigger is released and
tool
can cy-
cle.