i-32V5 Air/Water heat pumps wih axial fans
32
-
-
-
CLEANING OF EXTERNAL SURFACES
The sheets of the outer casing must be properly cleaned to avoid the accumulaon of dust / dirt, prevenng the onset of corrosion. The painng
ensures resistance to atmospheric agents but it is good pracce to make sure to remove any dirt present, cleaning the surfaces with neutral
detergent and water, especially if the unit is installed in places with an aggressive atmosphere (high level of polluon, salt, etc.).
EXTRAORDINARY MAINTENANCE
All extraordinary maintenance jobs must be carried out by an authorised assistance centre.
10. DECOMMISSIONING
Once the unit has reached the end of its life cycle and needs to be replaced, the following operaons are recommended:
• the refrigerant has to be recovered by trained personnel and sent to proper collecon centres; according to the procedures indicated in
Regulaon No. 517/2014 on uorinated greenhouse gases;
• any anfreeze addives in the water circuit must be recovered and disposed of properly;
• the compressors’ lubricang oil has to be collected and sent to proper collecon centres;
• the electronic components, such as regulators, driver boards and inverters, must be disassembled and sent to proper collecon centres;
• The structure and the dierent components, if unusable, must be scrapped and divided according to their nature; there is especially a good
amount of copper and aluminium in the machine.
These operaons allow easy material recovery and the recycling process, thus reducing the environmental impact in accordance with the provi-
sions of Direcve 2012/19 / EU on waste electrical and electronic equipment (RAEE).
The user is responsible for the proper disposal of this product, according to naonal regulaons in the country of desnaon of the appliance.
For more informaon, you should contact the Installaon Company or local competent authority.
-
-
RESIDUAL RISKS
This paragraph sets forth any residual risks which cannot be eliminated by the manufacturer in the design stage.
Risk due to:
Handing
There is always the risk of the unit falling or pping over during handling. Follow the instrucons in the “Handling”
secon and take all of the precauons foreseen according to local regulaons.
Installaon
Unsuitable installaon can cause water leaks, gas leaks, electric shocks, re hazards, malfunconing or damage of the
unit. Only qualied technical personnel can perform installaon.
Place the unit in an appropriate area and without the risk of ammable gas leaks. Make the installaon zone inacces-
sible to third pares.
To Next Page
Loading...
