i-32V5 Air/water inverter heat pumps with axial fansi
7
3. PERMITTED USE
• The company excludes any contractual and extra contractual liability for damage caused to persons, animals or objects, by incorrect instal-
laon, seng and maintenance, improper use of the equipment, and the paral or supercial reading of the informaon contained in this
manual.
• These units are built for the heang and/or cooling of water. Any other use not expressly authorised by the manufacturer is considered
improper and therefore not allowed. The uid to be used is exclusively water or a mixture of water and glycol in case of low water tem-
peratures.
• The installaon place and the water and electric circuit must be established by the plant designer and must take into account both technical
requirements as well as any applicable local laws and specic authorisaons.
• All work must be carried out by experienced and qualied personnel, competent on the exisng regulaons in country where the installa-
on takes place.
• This appliance is intended to be used by expert or trained operators in shops, light industry and in factories, or for commercial use by
non-expert personnel.
• The appliance may be used by children at least 8 years old and by persons with reduced physical, sensory or mental capabilies or without
experience or the necessary knowledge as long as they are supervised or aer they themselves have received instrucons on the safe use
of the appliance and understand the relevant dangers. Children must not play with the appliance. The cleaning and maintenance which the
user is expected to carry out on the unit cannot be done by children without supervision.
• Direct interacon with the unit by persons with electrically controlled medical devices, such as pacemakers, is prohibited, as harmful inter-
ference may result. It is recommended that an adequate distance be maintained from the installaon site of the unit, as indicated by the
medical system used.
4. GENERAL SAFETY REGULATIONS
Before starng any type of operaon on the units, every operator must be perfectly familiar with the operaon of the machine and its controls
must have read and understood all the informaon in this manual.
-
To Next Page
Loading...
