SAFETY INSTRUCTIONS 2 - 3
DSE-17www.maxcess.eu MI 1064 1 C
Sicherheit.fm
Personnel requirements The tasks listed in these operating instructions may only be
carried out by appropriately qualified personnel commissioned
by the operator. The responsibilities of the personnel for the
work on the system must be clearly defined by the operator.
Transport, assembly, Electrical connection or disconnection,
maintenance, troubleshooting, disassembly:
– Specialized staff
Mechatronics engineer, industrial mechanic, etc.
Control during operation:
– Specialized staff
Machine and system operators, etc.
– Personnel or trainees trained and supervised by the system
operator
Repair:
– Specialized staff
Service technician of Fife-Tidland GmbH
Preventing hazards – No changes may be made to the sensor.
– The parameters specified in Section
Technical data
must be
observed.
– Only accessory and replacement parts that have been
approved by Fife-Tidland GmbH may be used.
– The sensor may not be used as a support, handle or step.
There is a danger that the sensor will become damaged
(breaking off/snapping), resulting in personal injury.
Residual risks Installing the product in a machine/system makes it possible to
form clamping, squeezing and cutting points.
Despite a safe design and supplementary protective measures,
residual risks may remain for the machine/system in which the
product is installed. These risks must be recorded in a risk
assessment by the machine/system builder and taken into
consideration in the operating instructions.
To Next Page
Loading...
