Maxcess FIFE DSE-17 - Installation; Transport and Storage; Included with Delivery; Mounting

INSTALLATION3 - 1
DSE-17 www.maxcess.euMI 1064 1 C
3 INSTALLATION
Transport and storage – The sensor and/or the unit on which the sensor is mounted
must be secured against slipping during transport.
– The sensor must be stored in a cool, dry place.
– The sensor must not be stored in the vicinity of powerful
magnetic fields. The electronic components of the sensor
may be damaged.
Included with delivery – Sensor DSE-17
The model designation, part number, and the firmware and
configuration numbers are on the nameplates on the
housing.
– Operating instructions
Mounting
WARNING
 If a sensor is damaged, it must not be installed or placed in
operation.
 All assembly tasks on the sensor must be performed when
there is no electrical power in the system.
 Assembly tasks and mechanical settings must only be
performed when the machine has been stopped and has been
secured from being turned on again.
Mounting location –Protection Class: IP65
– Operating temperature: 10°C ... 50°C
– Relative humidity: up to 90% non-condensing
– Operating altitude: max. 3000m
–Protect from vibrations
– Not in the vicinity of strong magnetic fields
The electronic components may be damaged.
– Not in places where there is a risk of explosions.