TROUBLESHOOTING8 - 1
DSE-17 www.maxcess.euMI 1064 1 C
8 TROUBLESHOOTING
Error display LED H2 of the DSE-17 sensor flashes to indicates errors. The
flashing patterns identify the error.
When an error occurs, LED H2 flashes n times with a certain
pattern for 1second, followed by a 3-second pause. "n" and the
information corresponding to it are described in the table
below.
An error is displayed until it has been remedied.
Note:
Error display is suppressed during calibration.
"n" Error Remedy
2 No calibration data Calibrate the sensor again.
3 Hardware error (LED array) The error should not be remedied by the
customer.
The sensor must be sent back to
Fife-Tidland GmbH for repairs.
4 Temperature sensor faulty
5 Overtemperature error
Software version 1.022 an later:
The error is set at 65°C and canceled when the
temperature falls back to 55°C.
To Next Page
Loading...
