INTRODUCTION1 - 5
DSE-17 www.maxcess.euMI 1064 1 C
If there is no suitable contrast for an outer edge, it is assumed
that the edge is outside the field of view. The corresponding
extreme value of its signal range is assigned to the relevant out-
put functions.
Note:
When materials with unevenly distributed material thickness
(cloudy) are being scanned, this sensor behavior for blocking
web guiding (ASC job) by a corresponding setting or special
programming of the web guide controller should always be used
to prevented incorrect web guiding (for example for D-MAX
M404074).
table
page 9-2
Note:
The sensor is automatically calibrated to the transparency of the
material. If the density of the material is not distributed evenly
(cloudy), it is therefore possible that the output signal will be
subject to greater fluctuations than is the case without these
properties.
To Next Page
Loading...
