26
Basic Operations
Powering On/Off
Using Front Panel or Remote Control
Make sure the monitor is plugged into the wall outlet and the main AC switch located on the rear of the monitor
is switched to ON position. If the power is plugged in and the AC switch is on, the STATUS LED will illuminate
in orange color.
To turn power off, simply press the key on
the panel or the remote control once again.
Press the key on the panel or the remote
control.
The monitor will now turn on after a brief pause.
The STATUS LED will now turn green to
indicate power on status.
Using Discrete Power ON/OFF Keys
The discrete POWER ON/OFF keys send two discrete signals to the monitor, one for ON and one for OFF.
Because signals are discrete, these keys can be used by third-party universal remote controls for macro
programming.
POWER (Toggle)
To turn off power, simply press the button.
If the monitor is already turned off, pressing this
button will have no effect.
To turn power on, simply press the button.
If the monitor is turned on already, pressing this
button will have no effect.
Changing Inputs
Discrete
POWER ON/OFF
Using Front Panel or Remote Control
Pressing the INPUT key will cycle the monitor
through all available input signal sources in the
following order:
DVI
Press the INPUT key on the panel or the
key on the remote control.
Input Select
(Toggle)
To Previous Page
Loading...
Need help?
General