Need help?Do you have a question about the Maxfire CROSSFIRE LCD and is the answer not in the manual?
Details the three access levels for system functions and their permissions.
Explains the meaning of the main status LEDs on the control panel.
Details specific fault and status messages displayed on the LCD screen.
Allows setting zones as 'Automatic' or 'Intelligent' for pre-alarm timing.
Customizes zone names for easier identification of alarms or faults.
Defines zone pairs that must activate for an alarm event recognition.
Configures which zones trigger the Sounder 1 output.
Configures which zones trigger the Sounder 2 output.
Defines which zones trigger the Alarm Relay.
Defines which zones trigger the Fault Relay.
Sets the pre-alarm timing for 'Day Mode'.
Sets the ringing timer for Sounder 1 output.
Sets the ringing timer for Sounder 2 output.
Allows writing installer name and phone number.
Defines if programmed installer information is displayed.
Details the physical characteristics of the control panel.
Specifies operating conditions like temperature and humidity.
Lists electrical specifications like supply, fuses, and outputs.
Lists the default configurations for various settings.
General| Brand | Maxfire |
|---|---|
| Model | CROSSFIRE LCD |
| Category | Fire Alarms |
| Language | English |
To Next Page