92
The tablet will create a random ID for the MX-Sensor. Since this new ID is
different from the ID saved in the TPMS ECU, therefore the Relearn
function is needed to write the new ID into the TPMS ECU for the vehicle
recognizing the new MX-Sensor.
Figure 6-23 Sample Auto Create Screen
TPMS Relearn
This function is used to write the newly programmed sensor IDs into the
vehicle ECU for sensor recognition.
Only when the newly programmed sensor IDs are different from the original
sensor IDs, the Relearn function is needed to be performed. There are
THREE ways for Relearn.
Stationary Relearn
Active Relearn
OBD Relearn
Stationary Relearn
Stationary Relearn requires the vehicle in the “Learn Mode” then the
transmissions from all the TPMS sensors can be obtained in turn.
Tap Trigger to activate the new MX-Sensors first.
To Next Page
Loading...
