gate shut-off switch
Turn this feature ON while servicing the gate operator. This switch disables all OPEN/CLOSE devices BUT the JOG LEFT/RIGHT buttons
on MC-200 so gate can not accidentally get activated while operator is being serviced.
Only the Jog Left or Jog Right buttons will operate
gate when Gate Shut-Off switch is turned ON.
IMPORTANT: When the Gate Shut-Off switch is turned ON,
any OPEN/CLOSE command given to gate operator will just
“BEEP” for a few seconds and ignore command.
TECHNICIAN MAINTENANCE TIP: One wire can be unplugged from the back of the Gate Shut-Off switch after servicing the
operator to prevent the switch from accidentally being turned ON during normal operation. Plug the wire back in and turn ON the
switch only while servicing the operator. This can prevent an unnecessary service call by a technician when the only thing wrong
with a malfunctioning operator is the Gate Shut-Off switch has accidentally been turned ON but the owner is unaware of this.
MAX MC-200 motor controller
PhotoCell
Edge
UL
Entrap
1
2
Limit SW
ON-LINE
MATRIX
JOG
JOG
LEFT
RIGHT
Jog LT
Jog RT
GND
Edge 1
Edge 2
Photo
Cell
ERD
Motor
OverLoad
POWER
MC-200
Motor Controller
16
15
14
13
12
3
4
5
MAX
LED ON
Sensitivity
Edge
ERD
Gate Shut-Off Switch
11
UL 325 2016 Standard-MAX Quick Install Rev 8
To Next Page
Loading...
