23
1. Use runner switch to lower platform
to the ground (FIG. 23-1A). Release
switch when platform reaches
ground level.
Before lowering platform, make sure area surrounding platform is
clear of people and objects. If standing on platform, do not allow
your feet to extend beyond inboard edge of platform.
WARNING
!
3. Carefully move load off platform
(FIG. 23-2) and then move it to
a place where it will not become
a hazard for people and other
vehicles. If there is more to
unload from vehicle, repeat
the previous UNLOADING
VEHICLE steps for each load.
When unloading is fi nished,
use STOWING PLATFORM
procedure in this manual.
2. Pull up on lock mechanism
and lower retention ramp
to the ramp position (FIG.
23-1B).
LOWERING & UNLOADING PLATFORM
FIG. 23-1A
FIG. 23-1B
RAMP
POSITION
INBOARD
EDGE
MOVING LOAD OFF PLATFORM
FIG. 23-2
RUNNER
SWITCH
STAND CLEAR OF
PLATFORM
(REFER TO DECALS
& PLATES)
DOWN
To Next Page
Loading...
