32
1. Use column switch to lower (DOWN) platform
until it rests on bottom stops (FIG. 32-1). Release
switch when top edge of closed platform is below
bed height and dock level, and in the lower locking
position (FIG. 32-1). Now, loads can be moved
between dock and vehicle without using Liftgate.
LOWER LOCKING POSITION
FIG. 32-1
DOCK
Use dock plate for moving loads between dock and vehicle. Dock
plate must be supported by dock and vehicle fl oor. It must not
rest on Liftgate platform.
CAUTION
!
LOWER PLATFORM BELOW DOCK LEVEL
DOCK LOADING & UNLOADING
VEHICLE
FLOOR
PLATFORM
NOTE: Platform may be lowered with
vehicle backed up to dock.
DOWN
To Next Page
Loading...
