Maxon BMR-55 - Stowing Platform; Stow Retention Ramp

24
STOW RETENTION RAMP
STOWING PLATFORM
Push retention ramp
to stowed position as
shown in FIGS. 24-1A &
24-1B.
STOWED
POSITION
RETENTION
POSITION
1. Use the column switch to raise (UP)
platform (FIG. 24-2A) until runner arrow
and column decal on LH column are
aligned (FIG. 24-2B).
FIG. 24-1A
FIG. 24-1B
FIG. 24-2A
STOW PLATFORM
RAMP
POSITION
CAUTION
Platform and bottom stops could be damaged if platform is folded
with heel below the column bottom stops. Bottom stops will
interfere with folded platform being raised to up position. Prevent
damage by aligning arrow decals on column & runner before fold-
ing platform. Then, platform heel will be above the bottom stops.
UP
COLUMN
DECAL
RUNNER
ARROW
FIG. 24-2B