11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
PAGE 18
HYDRAULIC OVERRIDE LOCK
In the event that the BMR Column Lift will not lower, you will need to
disengage both of the Hydraulic Override Locks. There is one located at the
top of each Column.
To disengage, you must pull down on the Coil Nut and twist until it locks
into place. To re-engage you must twist the Coil Nut and release. It will spring
back into the original “Locked” position. Be sure to re-engage the Override
Locks before moving the vehicle.
COIL NUT
PULL DOWN AND
TWIST TO
DISENGAGE THE
LOCK
To Next Page
Loading...
