11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
PAGE 20
RELIEF VALVE PRESSURE SETTING
NEW STYLE RELIEF VALVE
The Relief Valve pressure is set at the factory. If adjustment is needed,
use the following instructions to set the pressure per the table below.
1. Attach a 0-3000 PSI gauge to the Pressure Port.
Actuate the Control Switch to the “Raise” position. Turn
the Relief Valve Adjustment Screw to the proper setting.
(Hint: Adjust the setting to approximately
300 psi below the desired pressure, and
slowly raise the pressure until you reach
the recommended pressure shown in
the table below.
RELIEF VALVE
ADJUSTMENT SCREW
3000 PSI
GAUGE
WARNING!
Setting the pressure higher
than recommended could
result in damage to your unit.
LEDOMLEDOM
LEDOM
LEDOMLEDOM.I.S.P.I.S.P
.I.S.P
.I.S.P.I.S.P
53-RMB53-RMB
53-RMB
53-RMB53-RMB05710571
0571
05710571
44-RMB44-RMB
44-RMB
44-RMB44-RMB00810081
0081
00810081
55-RMB55-RMB
55-RMB
55-RMB55-RMB00120012
0012
00120012
66-RMB66-RMB
66-RMB
66-RMB66-RMB00420042
0042
00420042
To Next Page
Loading...
