11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
PAGE 27
SWITCH AND HARNESS REPLACEMENT
4.
Remove the fitting from the lower port
of the Closing Cylinder. Remove the
opposite end of the hose from the bottom
of the Column. Remove the two bolts that
secure the Spring Guard to the unit. One
is located at the bottom of the Column,
the other is located between the bottom
two coils of the Spring Guard. This will
also remove a cable clamp. Set these
aside for re-assembly. The Spring Guard,
5. Remove the cable from the
fishing rope and attach the Switch
and Cable Assembly (P/N 260529
less the Switch), to the fishing
rope. Pull the rope back up
through the Runner and out the
Switch Mounting hole until the
cable is exposed. Leaving enough
slack in the cable to wire the
Switch properly, tighten the cable
clamp located just inside the
Switch Mounting hole and re-wire
the Switch per the diagram below.
Re-assemble the Switch Plate
and Cover Plate. Attach the
fishing rope to the exposed end of
the cable.
Hose Assembly, and Cable should pull out as one unit. Pull down on the cable
inside the Runner until the fishing rope is exposed.
FISHING
ROPE
P/N 260529
P/N 260533
SWITCH
RED
BLK
GRN
WHT
FISHING
ROPE
REMOVE
2 BOLTS
To Next Page
Loading...
