Maxon GPT-3 - Step 10 - Finish Welding Liftgate to Vehicle

To Next Page

To Previous Page

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

STEP 10 - FINISH WELDING LIFTGATE TO VEHICLE

1. Weld each of the two Mounting

Plates to Vehicle Frame

(FIG. 24-1A).

MOUNTING PLATE

WELDING MOUNTING PLATE

FIG. 24-1A

TYPICAL -

BOTH

MOUNTING

PLATES

5/16”

VEHICLE FRAME

(TYPICAL TRUCK FRAME

SHOWN)

VEHICLE FRAME CUTOUT

(DASHED LINES)

Prevent damaged hydraulic hoses. Before welding next to hydraulic hoses, protect

the hoses with a heat-resistant cover such as a welding blanket.

CAUTION

2. After welding is done and Mounting

Plates are cool, remove the 4 Fiber-

glass Sleeves shown in FIG. 24-1B.

Then reinstall the Split Looms re-

moved in STEP 3 (FIG. 24-1B).

REINSTALLING SPLIT LOOMS

FIG. 24-1B

SPLIT LOOMS

MOUNTING

PLATES (REF)

FIBERGLASS

SLEEVES

FIBERGLASS

SLEEVES

Other manuals for Maxon GPT-3