Maxon GPT-3 - Step 13 - Weld Hook and Eye to Liftgate

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
27
BASE OF
PAD EYE, ONLY
1. Stow the Liftgate under hydraulic pressure
(FIG. 27-1).
STEP 13 - WELD HOOK AND EYE TO LIFTGATE
1/4”
2. Weld the Pad Eye (from Installation
Parts Bag) to Knuckle as shown in
FIG. 27-1.
3. Insert the Safety Hook through the Pad
Eye (FIG. 27-1). Next position the
Safety Hook Chain on the Extension
Plate as shown in FIG. 27-1. Leave
enough slack in the Chain to hook and
unhook the Pad Eye. Then weld the
free end of Chain to the inboard side of
the tubing on Extension Plate.
3/16”
INBOARD SIDE OF
TUBING, ONLY
EXTENSION PLATE
HOOK
(WITH CHAIN)
KNUCKLE
RH SIDE VIEW OF STOWED LIFTGATE
FIG. 27-1
PAD EYE