17
1. Place all loads as close as
possible to the inboard edge of
the platform with heaviest part
toward the pickup bed as shown
in FIG. 17-1. Move loads across
the ramp (FIG. 17-1) to the
platform, but never rest or raise
loads solely on the fl ipover and
ramp portion.
A load should never extend past the edges of the platform. Do
not place unstable loads on platform, do not allow load to exceed
lifting capacity of Liftgate, and do not ride on the platform.
WARNING
!
LOADING PLATFORM AT GROUND LEVEL
FIG. 17-1
LOADING VEHICLE
3. Carefully move the load into
vehicle (FIG. 17-2).
RAISING LOADED PLATFORM
TO BED HEIGHT
FIG. 17-2
2. Use switch to raise (UP)
platform from ground level to
bed height (FIG. 17-2). Release
switch when platform reaches
bed height.
INBOARD EDGE
To Next Page
Loading...
