18
UNLOADING VEHICLE
MOVING LOAD ON PLATFORM
FIG. 18-1
Pulling the load from vehicle to platform can result in a fall from
platform and serious injury. When unloading vehicle, always
push the load out on the platform.
!
WARNING
1. Unload the vehicle at bed level
(FIG. 18-1) as follows. Push
load out of the vehicle to cor-
rect position on the platform.
Place all loads as close as
possible to the inboard edge
of the platform with heaviest
part toward the vehicle body
as shown in FIG. 18-1.
A load should never extend past the edges of the platform. Do
not place unstable loads on platform, do not allow load to exceed
lifting capacity of Liftgate, and do not ride on the platform.
WARNING
!
Before lowering platform, make
sure area surrounding platform
is clear of people and objects.
WARNING
!
UNLOADING PLATFORM AT
GROUND LEVEL
FIG. 18-2
3. Carefully move load off platform
(FIG. 18-2) and then move it to
a place where it will not become
a hazard for people and other
vehicles. If there is more to
unload from vehicle, repeat
the previous UNLOADING
VEHICLE steps for each load.
When unloading is fi nished,
use STOWING PLATFORM
procedure in this manual.
2. Use control switch to lower
(DN) platform and load to the
ground (FIG. 18-1). Release
switch when platform reaches
ground level.
INBOARD EDGE
To Next Page
Loading...
