RECEIVING A CALL
On receipt of a call, the Busy LED (4) will illuminate yellow.
Wait until the incoming message has finished before starting
your own transmission.
Press and hold the fist microphone PTT button (located on
the side of the microphone) while making a transmission
speak clearly with the microphone approximately 5 to 8 cms
away release the PTT button to listen. The TX LED (3)
illuminates red whenever your radio is transmitting.
If your radio has been set-up for Transmit Time Limiting, your
radio will return to the Receive state after this transmit
period.
If your radio has been set-up for Transmit Lockout, you will
not be able to transmit if the channel is busy (Busy LED (4)
on)
MAKING A CALL
Before transmitting, it is recommended that you monitor the
channel to ensure that it is not in use. Select the channel
using or and press the Monitor button.
If the channel is clear, press the microphone PTT button.
The TX LED will turn red. Speak to the party you are trying
to call.
Listen to the acknowledgement from the called party and
then speak into the microphone in a normal manner. Release
the PTT button to listen.
BUSY
When your radio receives a signal above a preset minimum
level, the Busy LED will illuminate yellow to tell you that
there is activity on the channel you are switched to. Your
radio may be set up so that you hear who is talking straight
away or it may be set up to prevent this until the correct
CTCSS/DCS code is received.
Receiving CTCSS/DCS
Your radio may be set-up so that only calls with the radios
specified code will be heard. In normal operation, the radio
will remain quiet until the correct CTCSS/DCS code is
received. The status LED will glow green, the loudspeaker
will open and the message will be heard.
TRANSMIT TIME OUT TIMER
If set-up, your radio will stop transmitting after a preset
period of time. An audible alert is heard at the end of the
period.
ENGLISH
8
To Next Page
Loading...
