TRANSMIT LOCK-OUT
Your radio may be set-up to disable the transmitter when the
channel is busy. If the PTT button is pressed, an audible
alert will sound and the status LED will flash yellow.
MONITOR/TONE DEFEAT
Your radio may be set-up to either allow or dis-allow
monitoring of a channel. Short presses of the Monitor button
will toggle the monitor mode on and off.
When on, the radio will continue to receive even if the signal
is very low. This may assist clarity if the radio is operating at
the limit of its range.
CHANGE CHANNEL
The PM160 can access a maximum of 99 channels. Select
the channel using or .
SCANNING & PRIORITY LOOKBACK
Note: Your radio may or may not be configured for
scanning. Please ask your Dealer or System Supervisor for
specific details.
What is scanning?
Your radio is switched into Scan mode by selecting the scan
channel (see Dealer/System Supervisor for details). When
scan commences, it cycles through a set of channels. It is
pre-programmed to stop at any busy channel. When activity
stops on this channel, the radio waits a pre-determined time
to allow you to respond. If you dont transmit, the radio will
then continue with the scan.
Removing a channel from the scan list
If your radio is always stopping on an unwanted channel,
press the Monitor button while the scan has stopped on the
channel to remove it from the scan list.
Note: Scan list is reset when the radio is turned off then on,
or when the scanning is re-selected.
What is priority lookback?
If your radio is programmed for priority lookback, your
Dealer/System Supervisor will have assigned a priority
channel, and one or more lookback channels, press the PRI
Key (11) to enter priority lookback mode. The radio will
periodically check the priority channel for activity. If the
priority channel becomes busy, the radio will monitor this
channel in preference to the current channel.
ENGLISH
9
To Next Page
Loading...
