STATUS LED
AUDIBLE MESSAGES
Audible alerts, such as high and low tones, of long and short
duration, may be used. Your radio controller will be able to
give you details of the alerts used in your system.
USING THE PM160
Note: The availability of the functions described in this
section is dependent on the set-up of your radio. Please
consult your Dealer or Supervisor for further information.
RECEIVE ONLY ALERT
Your radio may be set-up to receive on a channel but not to
transmit. If the PTT is pressed on such a channel, the radio
will beep and the TX LED (3) will flash red.
SWITCHING THE RADIO ON
Switch the radio on by turning the volume control clockwise
until its clicks. An audible alert sounds on completion of the
automatic self-test.
ENGLISH
7
Status Desc. Tx Busy Call Scan Pri
Normal Power on ready
Channel Busy On
Receiving
Correct CTCSS/DCS On On
Transmit On
Tx-lock out Flash On Poss
Scanning On
Error General error Flash
To Next Page
Loading...
