24
HOOK
PUSH TO
CLOSE
LATCH
4. When loading the platform
at bed level, make sure
cart stops are open (FIG.
24-1). Push load out of the
vehicle to correct position
on the platform. Place all
loads as close as possible
to the inboard edge of the
platform with heaviest part
toward the vehicle body
as shown in FIG. 24-1.
If standing on platform
with the load, stand in the
footprint area shown and
comply with the WARNING
on page 18.
Pulling the load from vehicle to platform can result in a fall from
platform and serious injury. When unloading vehicle, always
push the load out on the platform.
WARNING
!
CART STOPS CLOSED
FIG. 24-2
5. Unload platform with cart stop
at ground level as shown in
FIG. 24-2. Make sure cart
stop is closed before mov-
ing load off the platform. To
close, push the cart stop and
hook in place (FIG. 24-3).
CLOSING CART STOPS
(RH SIDE OF FLIPOVER)
FIG. 24-3
6. Move load off the platform
as shown in FIG. 24-2.
NOTE: Cart stops are kept
closed with a hook
(FIG. 24-3). Make sure
latch is locked.
LOADING PLATFORM AT BED LEVEL
(DUAL CART STOPS OPEN)
FIG. 24-1
INBOARD
EDGE
VEHICLE
BODY
PLATFORM
CART STOPS
CART STOPS
To Next Page
Loading...
