Maxon TE-25 - Liftgate Operation Procedures; Lowering and Unfolding Platform

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
14
TABLE 14-2
6. Bolt on the pump cover (FIG. 13-1).
Torque the cap screws to 10-14
lb-in.
5. Pull out (no threads) fi ller cap (FIG.
14-1). Fill the reservoir with hydraulic
fl uid to level “H” shown in FIG. 14-1
and TABLE 14-1. Reinstall fi ller cap
(FIG. 14-1).
POWER DOWN FLUID LEVEL
TABLE 14-1
4. For power down power unit, check the hydraulic
fl uid level “H” in reservoir (FIG. 14-1 and TABLE
14-1). If needed, add fl uid to the reservoir as fol-
lows.
PLATFORM POSITION
FLUID LEVEL
“H”
STOWED 2-5/8” to 3-1/8”
VEHICLE BED HEIGHT 2-5/8” to 3-1/8”
ON THE GROUND 2-3/8” to 2-7/8”
ISO 32 HYDRAULIC OIL
RECOMMENDED
BRANDS
PART NUMBER
CHEVRON HIPERSYN 32
KENDALL GOLDEN MV
SHELL TELLUS S2 VX 32
EXXON UNIVIS N-32
MOBIL
DTE-13M, DTE-24,
HYDRAULIC OIL-13
PERIODIC MAINTENANCE
CHECKING HYDRAULIC OIL - Continued
POWER DOWN POWER UNIT
FIG. 14-1
FILLER
CAP
“H”
RESERVOIR
TABLE 14-3
ISO 15 OR MIL-H-5606 HYDRAULIC OIL
RECOMMENDED
BRANDS
PART NUMBER
CHEVRON FLUID A, AW-MV-15
KENDALL GLACIAL BLU
SHELL TELLUS S2 VX 15
EXXON UNIVIS HVI-13
MOBIL DTE-11M
ROSEMEAD THS FLUID 17111