MaxPower T Series - UPS Status Indicators and Abnormal States; Load Indicators in Backup Mode; Abnormal Status Indicators

LED5
LED6
LED4
LED3
LED2LED1
Buzzer
Operating Status
(Backup Mode)
2 Beeps / 1 Second
2 Beeps / 1 Second
2 Beeps / 1 Second
Load = 105 ~125 %.
1 minute later UPS
shutdown.
Load > 150% .UPS
Immediately
Shutdown.
Load = 126 ~ 150%.
10 seconds later
UPS shutdown.
NOTE
LED Code Explain
=Continuously Lit
= 1 Flash Every
0.1Seconds
LED Code Explain
=OFF Status
Abnormal Status Indicators
LED5
LED6
LED4
LED3
LED2LED1
Buzzer
Operating Status
Output circuit short
Inverter over voltage
Inverter under voltage
Beep continuously
Beep continuously
Beep continuously
Beep continuously
Beep continuously
Bus over/under
Voltage abnormal
Fan lock fault
Over temperature
Charger over voltage
Charger fault
Beep continuously
Beep continuously
Beep continuously
- 15-
Installation and Operating Instruction