2.3 Installation
Before installation, please read and understand the following instructions:
Placement
The UPS must be installed in a protected environment away from heat-emitting
appliances such as a radiator or heater. Do not install this product where
excessive moisture is present.
Ventilation
The location should provide adequate air flow around the UPS with one inch
minimum clearance on all sides for proper ventilation.
Charge the Battery
Your new UPS may be used immediately upon receipt. However charge loss
may occur during shipping and storage. So charging the battery for at least 8
hours is recommended to insure that the battery is fully charged.
To recharge the battery, simply leave the unit plugged into an AC outlet.
(This UPS will recharge in both the On and the Off status.)
To Next Page
Loading...