Chapter 2: Components/Systems 27
4600 SCB Owner’s Manual Supplement
1. Make sure the component/system that the strainer is connected to is turned OFF.
2. CLOSE the seacock that sends raw water to the strainer you are about to clean. The seacock must remain closed
until the strainer is completely reassembled.
3. Take apart the raw water strainer.
4. Remove debris.
5. Flush strainer with water.
6. Reassemble the strainer.
7. OPEN the seacock and check for leaks around the strainer. If no leaks are found, you may activate the component
or system.
Raw Water Washdown
The raw water
washdown
faucet is
located on the
forward deck
port-side tub.
• FLOODING HAZARD! The seacock that sends raw water to the strainer must be CLOSED
before disassembling the strainer to prevent the yacht from taking on water through the raw
water strainer assembly. Keep the seacock CLOSED until the raw water strainer is com-
pletely reassembled.
• SYSTEM DAMAGE HAZARD! After reassembling the raw water strainer, verify that the
seacock valve is OPEN before energizing the component/system.
CAUTION!
!
RAW WATER
WASHDOWN
FAUCET
VIEW OF FOREDECK
TO RAW WATER WASHDOWN FAUCET
To Next Page
Loading...
