2 RC12 Windlass
Preliminary Information
Introduction
Congratulations on your purchase of a Maxwell windlass. Please read these instructions carefully
to enable you to correctly install and maintain the windlass for years of trouble-free operation.
Note
Failure to follow the correct installation, operation or maintenance instructions will jeopardise your
safety and could invalidate the warranty.
Components
In addition to this instruction manual, the following components may be included with the windlass:
• Windlass
• Remote up/down control panel
• Circuit breaker/isolator panel
• 12V or 24V reversing solenoid
• Clutch (Bi –square)Handle
• Emergency retrieval handle
• Motor Bolt Kit
• Deck Cutout Details (At rear of manual)
• Small parts:
• Nuts
• Flat washer
• Spring washer
To Next Page
Loading...
