Need help?Do you have a question about the Maxwell RC12 and is the answer not in the manual?
General| Voltage | 12V DC |
|---|---|
| Motor Type | Permanent Magnet |
| Max Pulling Power | 1200 lbs |
| Rope Size | 1/2" |
| Chain Size | 1/4" |
Provides an introduction to the windlass and the importance of reading instructions for operation.
Lists the components that may be included with the windlass, such as control panels and hardware.
An exploded view illustrating the various parts that make up the windlass assembly.
A comprehensive list of all windlass parts with their corresponding item numbers, descriptions, and part numbers.
Diagram showing the mechanical components of the windlass's bottomworks and handle system.
List of parts for the bottomworks and handle assembly, including quantities and part numbers.
Essential considerations for foredeck layout, anchor fit, and rope/chain compatibility for installation.
Guidance on correctly orienting the windlass for an optimal rope and chain path.
Detailed steps for preparing the windlass and deck for installation, including safety checks.
Procedure for safely replacing the pressure arm and spring assembly on the windlass.
Methods for achieving proper windlass alignment on decks that are not flat.
Specific advice for boat builders on protecting the windlass from environmental damage during transport.
Diagram showing the typical arrangement of electrical components for the windlass system.
Recommendations for installing the solenoid pack in a dry, accessible location near the windlass.
Guidelines for positioning the circuit breaker/isolator for motor protection and system isolation.
Instructions for mounting the remote control panel to ensure operator visibility and terminal protection.
Safety considerations and positioning requirements for optional footswitches.
Detailed schematic illustrating the electrical connections for the windlass system.
Table providing recommended cable sizes for 12V and 24V systems based on cable length.
Essential warnings for safe windlass operation, including direction changes and motor cooling.
Practical advice and best practices for anchoring safely and effectively with the windlass.
Step-by-step instructions for lowering the anchor using the windlass and clutch handle.
Procedure for raising the anchor, including clutch adjustment and safe docking of the anchor.
Instructions for safely deploying the anchor using the free fall method.
Methods for manually operating the windlass using the clutch handle for raising or lowering.
Guide on utilizing the capstan drum for handling mooring lines or retrieving a second anchor.
Specifications for the correct types and grades of oil and grease for windlass maintenance.
A schedule outlining routine maintenance tasks and their recommended frequencies.
Procedures for cleaning and lubricating the above-deck components of the windlass.
Maintenance guidelines for under-deck components, including the gearbox, motor, and rope.
Technical data including pull ratings, speeds, motor types, and dimensions.
Detailed drawings showing the physical dimensions of the windlass for DC and hydraulic models.
To Next Page
