42
5.1.1.2 NEW OIL SPECIFICATIONS
Reducer lubricant: Mobil Glygoyle 460
5.1.1.3 NEW OIL SPECIFICATIONS
Hydraulic Oil: Mobil DTE FM 32
5.1.2 GREASING
Refer to Section 5.1.1.1 for recommended lubricants.
Use the Maintenance Checklist provide to keep a re-
cord of all scheduled maintenance.
1. Use only a hand-held grease gun for all greasing.
Air powered greasing systems can damage the
seals on bearings and lead to early bearing failure.
2. Wipe grease tting with a clean cloth before greas-
ing to avoid injecting dirt and grit.
3. Replace and repair broken ttings immediately.
4. If a tting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace tting if necessary.
5. Conveyor Bearings:
Only sealed bearings are used on the Conveyor.
Sealed bearings should never be greased more
often than weekly or every 50 hours. Do not over-
grease. Do not give bearing more than 1 shot of
grease each time it is greased. Once the bearing
seal is broken, the bearing must be greased each
day or the bearing will fail.
To Next Page
Loading...