Maytronics Dolphin Deluxe 4 User Manual (English)

Questions and Answers:

T
Tracy JosephAug 4, 2025
Why Maytronics Swimming Pool Cleaners doesn't climb the walls?
- P
  Paige SmithAug 4, 2025
  Your Maytronics Swimming Pool Cleaner might not be climbing walls due to several reasons. First, try cleaning the filter bag or cartridge. Also, check the chemical levels in your pool water, as improper levels can lead to algae growth, making the walls slippery; adjust the levels and scrub the walls if needed. Inspect the brushes to ensure they are not worn out. If you have a Deluxe 5 model, verify that the wall climbing mode is enabled on the remote control.
A
anthony60Aug 8, 2025
What to do if Maytronics Swimming Pool Cleaner only cleans part of the pool?
- S
  Sara AlexanderAug 8, 2025
  If your Maytronics Swimming Pool Cleaner is only cleaning part of your pool, first ensure there is enough slack in the cable for it to reach all areas. Try cleaning the filter bag or cartridge. If you have a Deluxe 4 model, push in the float on the cable side. Also, check the brushes to see if they are obstructed or worn out.
E
Elizabeth MartinezAug 14, 2025
What to do if Maytronics Swimming Pool Cleaner moves but does not clean the pool?
- C
  caitlin76Aug 14, 2025
  If your Maytronics Swimming Pool Cleaner moves but doesn't clean, start by cleaning the filter bag or cartridge. After starting the cleaner, watch it for a few minutes to ensure it keeps moving. If it stops, inspect the impeller and drive system for any stuck debris.
L
Leslie SnyderAug 19, 2025
How to fix a Maytronics Swimming Pool Cleaners that does not move?
- L
  Lisa MaxwellAug 19, 2025
  If your Maytronics Swimming Pool Cleaner isn't moving, first check that the power supply is plugged in, turned on, and the cable is securely connected to the power supply. Ensure the power outlet is working correctly and hasn't tripped the breaker. Turn the power supply off, wait 30 seconds, and then turn it back on. Unplug the power supply, open the impeller cover, and check for any obstructions in the impeller.
M
Marie OlsenAug 25, 2025
Why Maytronics Swimming Pool Cleaner floats instead of sitting on the floor of the pool?
- T
  Travis MelendezAug 25, 2025
  If your Maytronics Swimming Pool Cleaner is floating instead of staying on the pool floor, try removing the trapped air again. Also, while the cleaner is in the water, squeeze the combined brush/Wonder brush to ensure they are fully water absorbent.
M
Morgan RodriguezAug 28, 2025
How to remove kinks from Maytronics Dolphin Deluxe 4 cable?
- A
  Aaron HowardAug 28, 2025
  If your Maytronics Swimming Pool Cleaner cable has kinks, for Deluxe 4 models, push in the float on the non-cable side. To remove the kinks, stretch the cable out completely and let it sit in the sun for at least a day.

Maytronics Dolphin Deluxe 4 Specifications

General

Type	Robotic
Pool Type	In-ground
Weight	16.5 lbs
Weekly Timer	Yes
Pool Size	Up to 50 feet
Cable Length	60 feet
Filter Type	Top-loading fine filter basket
Cleaning Coverage	Floor, Walls, and Waterline