GI–8
FUNDAMENTAL PROCEDURES
• Depending on location:
— Sealant and gaskets, or both, should be
applied to specified locations. When sealant
is applied, parts should be installed before
sealant hardens to prevent leakage.
— Oil should be applied to the moving
components of parts.
— Specified oil or grease should be applied at
the prescribed locations (such as oil seals)
before reassembly.
End Of Sie
ADJUSTMENT
A6E201400004E12
• Use suitable gauges and/or testers when making
adjustments.
End Of Sie
RUBBER PARTS AND TUBING
A6E201400004E13
• Prevent gasoline or oil from getting on rubber
parts or tubing.
End Of Sie
HOSE CLAMPS
A6E201400004E14
• When reinstalling, position the hose clamp in the
original location on the hose and squeeze the
clamp lightly with large pliers to ensure a good fit.
End Of Sie
WGIWXX0032J
X3U000WAS
WGIWXX0034E
WGIWXX0035J
1731‑1E‑02C.book8ページ２００２年４月２６日 金曜日 午前１０時３０分
To Next Page
Loading...