ELECTRICAL SYSTEM
GI–11
GI
• Connectors can be disconnected by pressing or
pulling the lock lever as shown.
Locking connector
• When locking connectors, listen for a click
indicating they are securely locked.
Inspection
• When a tester is used to inspect for continuity or
measuring voltage, insert the tester probe from
the wiring harness side.
• Inspect the terminals of waterproof connectors
from the connector side since they cannot be
accessed from the wiring harness side.
Caution
•
••
•
To prevent damage to the terminal, wrap
a thin wire around the tester probe before
inserting into terminal.
WGIWXX0042E
X3U000WB1
X3U000WB2
WGIWXX0045E
1731‑1E‑02C.book11ページ２００２年４月２６日 金曜日 午前１０時３０分
To Next Page
Loading...