Mazda LF - Page 28

ENGINE
B–11
B
.
Connecting Rod Cap Disassembly Note
1. Inspect the connecting rod side clearance. (See B–22 CONNECTING ROD INSPECTION .)
2. Remove the connecting rod bolt from the connecting rod cap by tapping the bolt with a plastic hammer.
Note
• The tappets are numbered to make sure they are assembled in their original positions. When removed,
keep the tappets with the cylinder head they were removed from. Do not mix the tappets.
Main Bearing Cap Disassembly Note
1. Inspect the crankshaft end play. (See B–20 CRANKSHAFT INSPECTION .)
2. Loosen the main bearing cap bolts in two or three
steps in the order shown.
End Of Sie
1 Balancer unit (L3, L3 (with variable valve timing
mechanism))
2 Connecting rod cap
(See B–11 Connecting Rod Cap Disassembly Note)
3 Lower connecting rod bearing
4 Upper connecting rod bearing
5 Connecting rod, Piston assembly
6 Piston ring
7 Main bearing cap
(See B–11 Main Bearing Cap Disassembly Note)
8 Lower main bearing, thrust bearing
9 Crankshaft
10 Upper main bearing, thrust bearing
11 Oil jet valve
12 Cylinder block
13 Adjustment shim
AME2224E341
1731‑1E‑02C.book11ページ２００２年４月２６日 金曜日 午前１０時３０分