McCulloch PRO MAC 610 - Page 11

To Start
The throttle trigger has an adjustable screw to set the starting
idle speed. It has been set for best performance by the factory.
Should you need to readjust it, turning it counterclockwise will
increase the starting idle speed. Conversely, turning it
clockwise will decrease the starting idle speed. @
1. Place saw on a clear, firm and flat surface.
2. Move ignition/stop switch up to the "START" position.®
3. Push the control button for the compression release
(DSP) valve in to the open position (if saw is equipped
with DSP valve). ®
4. Pull the choke button out to the closed position (cold
engine only). ©
5. Depress the safety trigger with the palm of your hand,
then squeeze the throttle trigger open. @ ©
6. With thumb, pull back on the throttle latch, then release
the throttle trigger. Throttle is now partially open. © ©
11