18
121102
Installing Lower Release Sheets
(Grills Using Lower Release Sheets)
Note: The following steps pertain to grill
markets using lower release sheets, only. If
lower release sheets are not used, proceed to
“Start-Up of the Grill” on page 20.
WARNING! Upper release sheets
cannot be used on the lower grill surface. Poor
quality and potential food safety issues will
occur.
1. Clean the grill with a sanitizer-soaked grill
cloth to remove any debris on the grill.
(See Figure 15.)
Figure 15
2. Place the fan interlock switch in the ON
position. The controller will display the
message “OFF”. (See Figure 16.)
Figure 16
3. Press the key for 3 - 5 seconds. “AM
TOO COOL” and “AM FOLDED EGGS -
CLAM” will be displayed on the control
screen.
4. The screen will then display, “CLEAN
GRILL SURFACES,” followed by “CLOSE
PLATEN FOR AUTO LEVELING.”
5. Using a sundae spoon, distribute two level
spoonfuls of soy adhesion flakes over a
warm 3 ft. (1 m.) grill surface, allowing the
flakes to melt. (See Figure 17.)
Figure 17
6. Using a clean squeegee, spread the
flakes on the cooking zone.
(See Figure 18.)
Figure 18
7. Put on heat-resistant gloves.
(See Figure 19.)
Figure 19
To Next Page
