29
130117
37. Wash and rinse the grease pans in the
3-compartment sink.
38. Re-install the grease pans.
(See Figure 58.)
Figure 58
39. Press the key for 3 - 5 seconds. “AM
TOO COOL” and “AM FOLDED EGGS -
CLAM” will be displayed on the control
screen.
40. The screen will then display, “CLEAN
GRILL SURFACES,” followed by “CLOSE
PLATEN FOR AUTO LEVELING.”
41. Using a sundae spoon, distribute two level
spoonfuls of soy adhesion flakes over the
warm 3 ft. (1 m.) lower grill surface. Allow
the flakes to melt. (See Figure 59.)
Figure 59
42. Using a clean squeegee, spread the
flakes on the cooking zone.
(See Figure 60.)
Figure 60
43. With the longest side of the lower release
sheet facing the back of the grill, hold the
release sheet about one inch from the
end of each side. Align the back edge of
the release sheet with the back splash
and the side edge of the grill.
(See Figure 61.)
Figure 61
Note: Reverse the cooking side of the
release sheets on a daily basis (example:
black side on odd days; grey or brown
side on even days).
To Next Page
