Page UMC30
Parameter Range Function
RELEASE varies by module Rate at which expansion stops
HPF FREQ varies by module High Pass Filter (HPF) frequency for HPF applied to
expander input
LPF FREQ varies by module Low Pass Filter (LPF) frequency for LPF applied to expander
input
Gate Modules
THRESHOLD -48 to 0 dB Signal level (post expander HPF and LPF) at which gate
is opened (is otherwise closed at a level determined by
Range)
RANGE varies by module Maximum amount of signal level adjustment from
expansion
HOLD varies by module Amount of time gate will remain open after signal level
falls below selected threshold
ATTACK varies by module Rate at which gate opens
RELEASE varies by module Rate at which gate closes
HPF FREQ varies by module High Pass Filter (HPF) frequency for HPF applied to gate
input
LPF FREQ varies by module Low Pass Filter (LPF) frequency for LPF applied to gate
input
Saturation Modules - S671
SATURATION 0 to 100% Amount of signal build up generated to produce saturation
effect
TONE -100 to 100% Timbre adjustment to saturation characteristic
Saturation Modules - Moo-D
DRIVE 0 to 100% Amount of signal gain applied (pre saturation)
TONE -100 to 100% Timbre adjustment to saturation characteristic
LOW CUT 0 to 100% Amount of low frequency signal content reduction
Saturation Modules - D-100
DISTORTION 0 to 100% Amount of signal distortion/destruction
TONE -100 to 100% Timbre adjustment to distortion/destruction characteristic
LOW CUT 0 to 100% Amount of low frequency signal content reduction
To Next Page
Loading...