mcdsp.com
Page UMC31
McDSP 6060 Ultimate Module Collection
Parameter Range Function
GC-1 Module
GATE THR -48 to 0 dB Signal level at which gate is opened (is otherwise closed at
a level determined by Range)
GATE RANGE 0 to 100% Amount of signal reduction when gate is closed
HOLD on/off Enable a longer hold time causing gate to remain open
longer after signal level falls below selected threshold
COMP THR -48 to 0 Signal level at which compression is triggered
GAIN -24 to +24 dB Gain applied post compression
ATTACK varies by module Rate at which compression starts
RELEASE varies by module Rate at which compression stops
AUTIO 0 to 10 Engages automatic attack and release values that are signal
dependent
SOS Module
THR -48 to 0 dB Signal level at which de-essing is triggered
LO CUT on/off Enables removal of low frequency signals to reduce vocal
or dialog plosives
RECOVER 50 to 500 msec Rate at which de-essing stops
FAST ATTACK on/off Rate at which de-essing starts - when enables a faster rate
is selected
RANGE 0 to 100% Amount of de-essing applied
FREQ 1.6 to 16 kHz Frequency at which de-essing is detected and reduced
HF+ on/off High Frequency Plus mode to further attenuate de-essing
at frequencies about selected frequency
TAPE Module
ROLL OFF 30 to 300 Hz Frequency near which tape playback head low frequency
roll off and head bump are oriented
BUMP 0 to 100% Amount of playback head mis-alignment
HEAD Modern / Vintage Type of playback head
COMP 0 to 100% Amount of tape compression
TAPE GP9 or 456 Type of tape formulation used is the playback head
To Next Page
Loading...